BEST ACCESS SYSTEMS 34HW Spezifikationen PDF herunterladen (Seite 9)

Installation Instructions for 34HW–35HW IDH Max Mortise Locks

BEST ACCESS SYSTEMS

Indianapolis, Indiana

Installation Instructions for 34HW–35HW IDH Max Mortise Locks

Installing the lock

8 Pull field wire harness through door

1 Feed the field wire harness (connected to the inside

trim) into the field harness & reader wire hole and

down into the mortise cavity.

2 From the hinge edge of the door, fish the field wire

harness through the door to the hinge mortise.

Note: You can let the inside trim dangle from the field

wire harness while completing tasks 9 through 12.

9 Install mortise case

1 Remove the faceplate from the mortise case.

2 Insert the mortise case into the mortise cavity, while

feeding the sensor and solenoid wires into the mortise

cavity and out the sensor & solenoid wire hole to the

inside of the door.

Note: The field wire harness should be routed above and

behind the mortise case (depending on where the hole

through the door meets the mortise cavity).

3 Make sure there are 3″ to 4″ of slack in the field wire

harness to allow access to the control electronics

circuit board in the inside trim.

4 Secure the mortise case with the case mounting

screws.

Figure 8 Pulling the field wire harness through the door

Hinge mortise

Field wire

harness

Inside trim

Field harness &

reader wire hole

Inside of door

Figure 9 Installing the mortise case

Inside of door

Field wire harness

Inside

trim

Sensor & solenoid

wire hole and wires

Mortise

case

Mortise cavity

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

BEST ACCESS SYSTEMS 34HW Spezifikationen Seite 9

Kommentare zu diesen Handbüchern